Unlocking Iphone is not recommended, I won't take any responsibility for all problems that may caused while using this tools to modify your iPhone. Please make sure you know what you are doing.
This guide will show you how to jailbreak/unlock the original iPhone 2G only, not the iPhone 3G. Some important notes before we begin: You must have iTunes 8 installed and you must be on firmware 2.2.1, if you are not, be sure to update via iTunes. Also make sure to go into the task manager and disable ANYTHING Apple or iTunes related.
1. Get the tools.
Make sure you are running the 2.2.1 on your iPhone and have iTunes 8 installed.Get the tools you will need. Create a folder on your desktop named “Pwnage”, then download the following files into that folder:
Unrar/unzip the QuickPwn.zip file inside the Pwnage folder.
2. Launch QuickPwn
Click on the pineapple icon from the Pwnage folder you created on your desktop.
3. Connect your iPhone
Connect your iPhone via USB to your computer and click the blue arrow icon to continue.
4. Browse the Firmware
Now we have to click the browse button to locate your iPhone firmware.
5. Selecting the 2.2.1 firmware IPSW
Select the 2.1 firmware IPSW file from the Pwnage folder you created on your desktop then select the IPSW file and click the open button.
6. Firmware Verification
QuickPwn will now verify you have selected the correct firmware. After it is verified click the blue arrow to continue.
7. Customize your firmware
This step allows you select what you’d like installed on your iPhone. You have options to select Cydia, Installer, replace boot logos, and unlock your device. Once you have made your selections on the options, click the blue arrow to continue on. If you want a full unlocking, installing Cydia and Installer is highly recommended.
8. Bootloader Files
You will now be asked to select your bootloader files that I mention for you to download. Click on the Browse button and select the 3.9 bootloader from the Pwnage folder you created before. Use same method for the 4.6 bootloader file. Then click the blue arrow button to continue.
9. Verify Connection
QuickPwn will verify that your iPhone is still connected to your PC. Again click the blue arrow to continue.
10. Potential Tricky Part - Pay Attention
Ok, this part seems to give some people issues, but I assure you it does work. QuickPwn will now put your iPhone into recovery mode. When its in recovery mode you will be given directions to: Hold the Home button for 5 seconds, Hold the Home and Power buttons for 10 seconds, then release the Power button and continuing holding the Home button until your iPhone is in DFU mode.
11. Wait for the unlocking begin - no turns back now!
QuickPwn will detect your phone is in DFU mode and proceed with the jailbreaking process.
12. You are officially jailbroken - Congratulations! Now Time to Unlock - Be Patient
Once jailbreaking is complete, QuickPwn will then reboot it and run BootNeuter. Let BootNeuter take over, do not interupt it. This process will take about 5 minutes. Your iPhone will reboot when it has completed and you will have a fully unlocked iPhone!
13. Setting up data connection - T-Mobile ONLY
Go into Settings, General, then Network and enter the following information.
APN: wap.voicestream.com
Username: (leave empty)
Password: (leave empty)
No comments:
Post a Comment